da0776ff12
* Setting up dry contact protocol * limit switch implementation * setup door controls * Initial commit to make the component aware of the dry_contact sensors… (#249) Initial commit to make the component aware of the dry_contact sensors and eliminate the need for lamda calls Co-authored-by: bradmck <bradmck@gmail.com> * send both sensor values * removing irrelevant dry contact config * Add triple button (discrete) control for commercial openers & gates * point to git * Add dry contact to installer * rm whitespace * updated wiring diagram * organize dry contact methods & fix initial limit switch state --------- Co-authored-by: bradmck <bradmck@gmail.com> |
||
|---|---|---|
| .github/workflows | ||
| components/ratgdo | ||
| static | ||
| .pre-commit-config.yaml | ||
| LICENSE | ||
| README.md | ||
| base.yaml | ||
| base_drycontact.yaml | ||
| base_secplusv1.yaml | ||
| library.json | ||
| ratgdo.yaml | ||
| v2board_esp32_d1_mini.yaml | ||
| v2board_esp32_lolin_s2_mini.yaml | ||
| v2board_esp8266_d1_mini.yaml | ||
| v2board_esp8266_d1_mini_lite.yaml | ||
| v25board_esp32_d1_mini.yaml | ||
| v25board_esp32_d1_mini_secplusv1.yaml | ||
| v25board_esp8266_d1_mini.yaml | ||
| v25board_esp8266_d1_mini_lite.yaml | ||
| v25board_esp8266_d1_mini_lite_secplusv1.yaml | ||
| v25board_esp8266_d1_mini_secplusv1.yaml | ||
| v25iboard.yaml | ||
| v25iboard_drycontact.yaml | ||
| v25iboard_secplusv1.yaml | ||
README.md
ratgdo for ESPHome
This is a port of the ratgdo software for the v2.0/v2.5 board to ESPHome.
Visit the github.io page to purchase boards
Installation
- Flash the ESPHome based firmware using the Web Installer
It is no longer necessary to save the rolling code counter when switching between firmware.
First use after adding to Home Assistant
The ESPHome firmware will allow you to open the door to any position after calibration. To calibrate the door, open and close it once without stopping.
ESPHome config
