Merged revisions 310635 via svnmerge from

https://origsvn.digium.com/svn/asterisk/branches/1.6.2

................
  r310635 | rmudgett | 2011-03-14 11:47:54 -0500 (Mon, 14 Mar 2011) | 32 lines
  
  Merged revisions 310633 via svnmerge from 
  https://origsvn.digium.com/svn/asterisk/branches/1.4
  
  ........
    r310633 | rmudgett | 2011-03-14 11:38:24 -0500 (Mon, 14 Mar 2011) | 25 lines
    
    "Caller*ID failed checksum" on Wildcard TDM2400P and TDM410
    
    The last character in the caller id message is getting a framing error.
    
    The checksum is the last character in the message.  A framing error in the
    checksum could be because:
    1) The sender did not send a full stop bit.
    2) The sender cut off the FSK carrier too soon.
    3) The sender opted to send zero of the specified zero to 10 trailing mark
    bits and round-off errors in the code resulted in the code not being where
    it thought it was in the demodulated bit stream.
    
    Bit 8 of 'b' is set when parity error.
    Bit 9 of 'b' is set when framing error.
    
    Made ignore the framing and parity error bits if the errored character is
    the checksum.  We can tolerate a framing/parity error there.  The checksum
    character validates the message.
    
    (closes issue #18474)
    Reported by: nivek
    Patches:
          callerid.c.1.patch uploaded by nivek (license 636) (with modifications)
    Tested by: nivek
  ........
................


git-svn-id: https://origsvn.digium.com/svn/asterisk/branches/1.8@310636 65c4cc65-6c06-0410-ace0-fbb531ad65f3
This commit is contained in:
Richard Mudgett
2011-03-14 16:50:59 +00:00
parent 7ea558865a
commit a6bb331e18

View File

@@ -568,9 +568,22 @@ int callerid_feed(struct callerid_state *cid, unsigned char *ubuf, int len, form
return -1;
}
if (res == 1) {
/* Ignore invalid bytes */
if (b > 0xff)
continue;
if (b > 0xff) {
if (cid->sawflag != 5) {
/* Ignore invalid bytes */
continue;
}
/*
* We can tollerate an error on the checksum character since the
* checksum character is the last character in the message and
* it validates the message.
*
* Remove character error flags.
* Bit 8 : Parity error
* Bit 9 : Framing error
*/
b &= 0xff;
}
switch (cid->sawflag) {
case 0: /* Look for flag */
if (b == 'U')